how to light coal forge

Best answer


Take a ball of newspaper and crumple it into a small, tight ball. then hold the ball of paper against the coaland lightit. The flame will spread to the coaland start the fire. Once the fire is going, you can adjust the air flow by adjusting the damper on the forge. Be sure to keep an eye on the fire and adjust it as necessary.

People also ask


  • Can you use a clinker to light a coal forge?

  • Clinkers have no use in blacksmithing. I should note that the forge should be all cleaned up before starting a new fir e. A huge build-up of clinkers and other waste products will make it nearly impossible to light it. So, when all that is set and done, you are ready to start a fire. Sometimes, lighting anthracite coal will take patience and time.

  • How do you break up coals in a fire?

  • Once your fire is lit poke it gently to release ash and break-up coals that may have stuck together through tar production. Arrange your cinders (step 1) around the edge, and add more coal around the periphery of the fire you have stared.

  • How do you add coal to a wood burning fire?

  • Add a little at the back, or the sides, or in the centre. Coal needs time to warm up, if you smother the fire with cold-coal you’ll kill the lovely heat, and it will take longer to burn up. pile it up around the edges, when it starts burning: poke and rake it into the centre gradually. Did you make this project?

  • What are the different types of coal used for forging?

  • During forging, coal goes through 4 phases. Green coal is the starting point of any coal transformation where it is not burned yet. The most popular ones are anthracite and bituminous coal. Anthracite is considered as hard coal whereas bituminous as soft coal. Each type has its advantages and disadvantages.

    Leave a Reply

    Your email address will not be published.